TPFA
Press-fit filler breather with dipstick and filter
Technical Sheet
Material
Plug made from thermoplastic material (Polyamide 66) ensuring a high mechanical resistance at both low and high temperatures, dimensional stability and shock resistance.
Dipstick made from shosphated steel Polyurethane foam air filter (indicative filtration degree 50 microns), which can be easily replaced by taking off the red lid.
Seal with (NBR) 70 Shore O-Ring, located in the special seat.
Description
Cylindrical-headed filler breather with vertical ribs for an optimal grip.
Dipstick with 205mm standard length, measured fron the end stop and with filter.
This item has a wide vent capacity, therefore it should be used on tanks or hydraulic plants subject to quick volume changes and a consequent recall of large air volumes and generally without oil splashes. Airflow capacity (P) shown in the table expressed in litres/minute, measured with a pressure of 50 mbar.
Colour
Black with red lid.
Assembly
Press-fit.
Notes
Upon request and for minumum quantities of at least 250 pieces the dipstick can be supplied in the different lengths with min-max notches.
Package
1 - 50 - 100 pcs.
2D and 3D technical drawing
To download the 2D and 3D drawings, you must be registered to Thenar's website.
If you are already registered, do the login here.
Login failed or account not yet been confirmed
Aren't you registered?
Registration not yet confirmed
To download the 2D and 3D drawings, you must wait for Thenar's authorization. When you are authorized, you will be notified by email.
If you want to ask for the authorization to download the drawings, please click here:
FOLLOW US ON