TMDA
Filler breather with dipstick
Technical Sheet
Material
Plug made from the thermoplastic material (Polyamide 66), ensuring a high mechanical resistance at both low and high temperatures, dimensional stability and shock resistance.
Dipstick made from phosphated steel, round section. Seal with 70 Shore synthetic rubber O-Ring, oil resistant.
Description
Filler breather with round head and vertical ribs for a better grip. Manual tightening.
The plugs of this series allow a wide airflow through the four vents located under the thread and six vents under the grip.
To be used on hydraulic plants or tanks containing liquids which are subject to quick volume changes, where a rapid air outlet or the recall of large air volumes are needed.
Generally the plug is not stressed by oil splashes or leakages. Dipstick with 200 mm standard length.
Colour
Black with red lid.
Notes
Upon request, for minimum orders of 250 pieces, the dipstick can be supplied with a different length and notches indicating min-max oil level.
Airflow capacity(P) shown in the table expressed in litres/minute, measured with a pressure of 50 mbar.
Upon request, NPT conical thread is available on 3/8"-1/2"-3/4"-1"G.
Package
1 - 50 - 100 pcs.
2D and 3D technical drawing
To download the 2D and 3D drawings, you must be registered to Thenar's website.
If you are already registered, do the login here.
Login failed or account not yet been confirmed
Aren't you registered?
Registration not yet confirmed
To download the 2D and 3D drawings, you must wait for Thenar's authorization. When you are authorized, you will be notified by email.
If you want to ask for the authorization to download the drawings, please click here:
FOLLOW US ON