TMDFA / TMDFA - BR

Material

Plug made from thermoplastic material (Polyamide 66), ensuring high mechanical resistance at both low and high temperatures, dimensional stability and shock resistance.
Phosphated steel dipstick, round section Filter in sintered bronze for version TMDFA/BR. Oil resistant O-Ring seal, 70 Shore.

Description

Filler breather with round head and vertical ribs for a better grip; manual tightening. Dipstick with 200 mm standard length.
The plugs allow a wide airflow through the four vents located under the thread and six vents under the grip.
They are recommended to be used on hydraulic plants or tanks containing liquids which are subject to quick volume changes, where a rapid outlet or the recall of largeair volumes are needed.
Generally the plug is not stressed by oil splashes or leakages.
They are equipped with a polyurethane foam filter, as standard equipment (indicative filtration degree 50 microns) for work applications in very dusty environments.
This filter can be easily removed, for its replacement, by taking off the red lid, manually.
Airflow capacity (P) shown in the table, expressed in litres/minute, measured with a pressure of 50 mbar in critical applications where the vent hole is subject to strong oil splashes, especially during the starting of the macine when the oil is still sticky.
We suggest the use of the series TMDFA/BR, with sintered bronze air filter (indicative filtration degree 30 microns) whick allows the air to flow but stops oil overflowing due to the bronze filter being not absorbent, when it gets in contact with the fluid.

Colour

Black with red lid.

Notes

Upon request and for a minimum quantity of 250 pieces, the dipstick can be supplied with different lengths, and with min-max notches.
Upon request NPT conical thread is available on 3/8"-1/2"-3/4"-1".

Package

1 - 50 - 100 pcs.

Download Technical Sheet PDF file

Buy online

Ask for Thenar Catalogue

Technical Sheet